© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
F232201
22
Stop Routine
The operator can select the agitation which will be in
effect for the STOP routine “shakeout.” To minimize
cycle time, if rotation has stopped, the control
shakeout time is brief. This will help prevent tangling
of the load and provide maximum control. Three
agitations are available for the STOP routine. They are
as follows:
Wash 1
• 12 seconds forward
• 3 seconds pause
• 12 seconds reverse
• 3 seconds pause
Wash 2
• 3 seconds forward
• 27 seconds pause
• 3 seconds reverse
• 27 seconds pause
Wash 3
• no rotation
To select the agitation in the stop routine, program a
Wash 1, 2, or 3 step for 1 second. The washer-
extractor will begin refilling to the most recent water
level if the time is more than 1 second. If the most
recent wash type was Wash 4, 6, or 7, the WE-6 will
default to no agitation (Wash 3) during the stop
routine.
NOTE: If the desired action is not programmed in
the final cycle step, the control will default to the
most recent action in the cycle. If the cycle stops
prematurely, the most recent action at the time the
cycle is interrupted will be in effect during the stop
routine.
The display will read “W1-cc,” “W2-cc,” or “W3-cc”
for Wash 1, Wash 2, or Wash 3 action during the
shakeout portion of the stop routine until the final
10 seconds. (The “cc” here stands for the current cycle
number and will be represented by numbers in the
actual display.) During the final seconds, the display
reads “STOPcc.” The display will then read
“DONEcc.” At that point, the door can be opened. If
rotation is sensed, control does not allow door to open.
In stop routine, the coast time ensures a minimum time
for coast. After the minimum, the control determines if
rotation sensor is working, then a short shake-out
routine begins when cylinder rotation stops. At the end
of shake-out routine, “STOPxx” displays briefly, then
displays “donExx”, if there is no rotation. If rotation is
sensed, control does NOT show “donE” and prevents
door from being opened. When no rotation is sensed,
door can be opened.
NOTE: If control detects that rotation sensor is not
working upon entering the stop routine, all stop
procedure times default to maximum values. Refer
to Programming manual for additional
information.
NEVER insert hands or objects into basket
until it has completely stopped. Doing so
could result in serious injury.
SW012
WARNING