© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
15
F232201
Display Interpretations
HRWC__
ARWC__
Program identification code (ROM). This
is an example only.
DONE End of cycle
DOOR Door not locked problem
EMTY Empty problem
FILL Fill problem
SDLY Spin coast delay
NEXT Select cycle or open door or select program
NCYC Cycle not available
STOP Stop button pressed or cycle ended
A1 Auxiliary output #1
A2 Auxiliary output #2
A3 Signal
CF Cold flush
CH Cold fill to high level
CM Cold fill to medium level
CL Cold fill to low level
CO Cold fill to overflow
CR Cold rinse
CY Cycle number
D1 Drain #1
D5 Identical to Drain #1 without rebalance
attempts – reduces drain time. Do not
program an H3 spin after this step.
Da Drain to optional reuse tank A
Db Drain to optional reuse tank B
F Heat select temperature in ° Fahrenheit
C Heat select temperature in ° Centigrade
HF Hot flush
HH Hot fill to high level
HM Hot fill to medium level
aL Fill from reuse tank A to low level
SEt UP Perform model setup routine
aM Fill from reuse tank A to medium level
Ta bl e 1
aH Fill from reuse tank A to high level
bL Fill from reuse tank B to low level
bM Fill from reuse tank B to medium level
bH Fill from reuse tank B to high level
HL Hot fill to low level
HO Hot fill to overflow
HR Hot rinse
H1 High speed #1
H2 High speed #2
H3 High speed #3 (default)
H3 High speed #3 (maximum)
HT Heat (steam or electric)
--M Minutes (used when programming time)
--S Seconds (used when programming time)
MS Medium speed spin
SK Soak
S1 Supply #1 (Detergent)
S2 Supply #2 (Bleach)
S3 Supply #3 (Sour)
S4 Supply #4 (Softener)
S5 Supply #5 (Specialty)
TH Controlled temperature fill to high level
TM Controlled temperature fill to medium
level
TL Controlled temperature fill to low level
TO Controlled temperature overflow
W1 Wash 1 (normal reversing)
W2 Wash 2 (gentle reversing)
W3 Wash 3 (no agitation)
W4 Wash 4 (medium reversing action)
TEST?/
SPEED
Test rotation sensor
W5 Wash 5 (temp.-controlled cool-down)
Display Interpretations
Table 1