Filter
Top Products
450431-3 www.amdry.com 19
Remove old motor pulley and bushing and place on new
motor. Follow “To Replace Motor Pulley”.
Reverse these steps to replace drive motor.
To Replace Impellor Motor
(Fan Shaft Drive – 50/60 Hz Gas and Steam Models)
Discontinue electrical power to the dryer.
Remove the lint drawer.
Remove the lint door.
Remove the left hand lint wall.
Loosen the four mounting bolts securing the motor.
Loosen the tension bolts.
Remove V-belts.
Disconnect motor wiring.
Remove the motor pulley and bushing.
Reverse these steps for installation of new motor.
To Replace Fan Shaft and/or Fan Shaft Bearings
To remove from the front, follow the instructions from “To
Replace Impellor Motor”.
Remove the two left-handed jam nuts that hold the impellor
to the fan shaft.
Remove the impellor, washers, and the key.
Loosen the four bolts securing the fan shaft assembly to
the base of the dryer.
NOTE: Models with rear access, it may be easier to
remove this plate, to remove the two rear fan shaft
assembly bolts.
Remove the fan assembly through front access hole.
Loosen the setscrews in each bearing.
Loosen the four flange bolts and two pillow block bolts.
Using a pulley, remove the bearing needing replacing.
Reverse the procedures to reinstall new bearing.
Impellor
Discontinue electrical power to the dryer.
Remove the left side lint wall if necessary for easier access.
Remove the six nuts securing the inlet cone to the blower
housing.
Remove the two left-handed jam nuts that hold the impellor
to the fan shaft.
Remove the impellor, washers, and the key.
Replace the impellor, key, washers, left-handed jam nuts,
and the side panel.
Reestablish electrical power to the dryer.
Lint Drawer Assembly
To Replace Lint Screen
Pull out lint drawer.
Remove lint screen from lint drawer.
Drop new lint screen in place.
Slide lint drawer back into dryer.