54 RXiIIIPlus User Guide 6/21/2004 23063L-001 Rev. 2
Front Panel Controls
Front Panel LCD
MEDIA POWER
UP
Media Power Up
This parameter sets the action of the labels when the printer is turned on.
• Press the right or left oval to display the choices.
Default: Calibration
Selections: Feed, Calibration, Length, Short Cal, and No Motion
• Feed—feeds the labels to the first registration point.
• Calibration—determines the length of the label and adjusts the sensor settings.
• Length—In continuous mode, feeds the last stored label length. In non-continuous
mode, calibrates based on the maximum label length setting (see Setting Maximum
Length on page 46).
• Short Cal—calibrates label length using the current sensor settings.
• No Motion—the media does not move. You must press
FEED to cause the printer
to resynch to the start of the next label.
HEAD CLOSE
Head Close
This parameter sets the action of the labels when the printhead is closed.
• Press the right or left oval to display the choices.
Default: Calibration
Selections: Feed, Calibration, Length, Short Cal, and No Motion
• Feed—feeds the labels to the first registration point.
• Calibration—determines the length of the label and adjusts the sensor settings.
• Length—In continuous mode, feeds the last stored label length. In non-continuous
mode, calibrates based on the maximum label length setting (see Setting Maximum
Length on page 46).
• Short Cal—calibrates label length using the current sensor settings.
• No Motion—the media does not move. You must press
FEED to cause the printer
to resynch to the start of the next label.
BACKFEED
Backfeed Sequence
This parameter establishes when and how much label backfeed occurs after a label is
removed or cut in Peel-Off, Cutter, and Applicator modes. It has no effect in Rewind or
Tear-Off modes. This parameter setting can be superseded by the ~JS instruction when
received as part of a label format (see the ZPL II Programming Guide).
Note • The difference between the value entered and 100% establishes how much
backfeed occurs before the next label prints. For example, a value of 40 means that 40% of
the backfeed takes place after the label is removed or cut. The remaining 60% takes place
before the next label prints. A value of
BEFORE
means that all backfeed takes place
before the next label prints.
• Press the right or left oval to display other choices.
Default: DEFAULT (90%)
Selections:
DEFAULT, AFTER, OFF, BEFORE, 10%, 20%, 30%, 40%, 50%,
60%, 70%, 80%
Table 5 • Printer Parameters (Sheet 11 of 15)
Parameter Action/Explanation
