Working with Memory Modules
4. Touch the static-protective package containing the DIMM to any
unpainted
metal surface on the server; then, remove the memory module from the
package.
5. Position the DIMM so that the two key slots (openings in the connector pins) on
the bottom edge align with the corresponding sections in the connector.
6. After aligning the DIMM, push the DIMM firmly straight down into the connector.
(The retaining clips on both sides of the connector automatically come up into
the notches on the sides of the DIMM when the DIMM is properly seated.)
Notch
Note: Adding or removing DIMMs changes the configuration information in the
server. When you restart the server, the system displays POST error
164. Select Continue; then, in the Configuration/Setup Utility program,
select Save Settings.
7. If you want to install or remove any other options, do so now. Otherwise, go to
“Completing the Installation” on page 76.
Chapter 4. Installing Options 55
