Installing the Rack Model in a Rack Enclosure
To prepare the Netfinity 5000 server for installation in a rack enclosure:
1. Attach the cable-arm bracket to the rear of the server.
a. Remove the two screws at the left of the primary power supply.
b. Align the cable-arm bracket with the screw holes, keeping the solid arm of
the bracket toward the side of the server. Make sure the openings in the
bracket align with the power supply LEDs and the fan.
c. Attach the bracket with the two screws you removed in step 1a.
2. Attach the inner slide section of each slide rail to the side of the server.
a. Pull the inner slide until the safety latch locks.
b. Press the safety latch; then, pull the inner slide firmly until it detaches from
the outer slide rail.
c. Align the holes on the inner slide with the holes on sides of the server;
then, attach the slide with three pan-head short screws (M4 by 5 mm).
Chapter 5. Installing a Server in a Rack Enclosure 97
