Avaya, Inc. - 66 - PARTNER ACS 1600 DSL module User Guide
• ATM Slot - ATM slot number for this ID.
• VPI - the ATM virtual path identifier (VPI) for this ID.
• VCI - the virtual circuit identifier (VCI) for this ID.
For more information about a connection, type the ID number,
and then press ENTER.
4. Default Interworking Connections
Restores the default interworking connections.
D. Configure
DHCP Server
Displays the DHCP Server Configuration Menu, which
contains the following commands to configure DHCP.
DHCP dynamically assigns an IP address to all devices
connected to the PARTNER ACS 1600 DSL module. You
must select the Ethernet Interface to correctly use the
following commands.
You must restart the PARTNER ACS 1600 DSL module for
the changes to take effect. For more information on restarting
the PARTNER ACS 1600 DSL module or on upgrading your
software using TFTP, see the “PARTNER ACS 1600 DSL
module basics” chapter.
E. Enable/Disable DHCP
Enables and disables DHCP.
B. Enable/Disable DHCP Debug Messages
For factory use only.
I. Configure DHCP Server Parameters
Sets the DHCP server parameters.
Type the number of the Interface, the number of the port, the
following information, and then press ENTER:
• Gateway IP address
• DNS Server IP address
• NetBIOS Server IP address
• Subnet Mask
• Domain Name
• DHCP Lease Time
