Overwrite warning screen (Figure 2C).
The iStep system will now begin copying files
onto your hard drive. If you want to cancel for
any reason, click the ‘Cancel’ button on the
copy progress screen
(Figure 2D).
Figure 2E displays the destination drive and
folder where the iStep system is being
installed. Should the progress indicators
stop moving, and the destination file name
does not change, your system may be hung
up. Wait a few minutes and restart. For
technical assistance contact iStep Technical
Support at 1-800-644-3514.
Once iStep has copied the necessary files onto
your hard drive, it will ask if you want to install
the VB runtime. (Figure 2F. VB Runtime screen.)
This installation is necessary to make your
iStep system run properly. Click the ‘Yes’ button.
After the VB runtime has been installed correctly,
click ‘OK.’ The Microsoft Data Access
Components 2.0 program installation will then
begin. Click ‘Yes’
Click ‘Continue’ to accept the user
agreement.
(Figure 2G)
Click ‘Complete’ to install the complete
package. When all of the files have been
copied onto your computer
, the Setup Finish
screen (Figure 2H) will appear.
You will now need to restart your computer
in order to begin using the iStep program.
Click ‘Finish’ to complete the installation.
Launching the Program
The installation will place four icons on
your desktop (Figure 2I). They are: iStep
Aetrex V5 F.I.T.; iStep Aetrex V5; iStep Lynco
V5 F.I.T.; and iStep Lynco V5. The iStep F.I.T.
icons will launch the iStep program that will use
the F.I.T. features. If you do not have the F.I.T.
upgrade device, launch the iStep Lynco or
Aetrex programs, which will use the iStep
device only.
8
Manual
Fig. 2C
Fig. 2D
Fig. 2E
Fig. 2F
Note: Please do
not make changes
to the configuration
without contacting
iStep
Technical
Support first!
Fig.
2G
