ACS XFC-S Manual

A SERVICE OF

next previous

29

7.5.2. XFC-K

Use the following procedure to clean or replace the filter cartridge:

1. Open the toggle fasteners on the lid of the filter.

2. Remove the filter lid and cartridge.

3. Remove the locking pin and lock nut to separate the cartridge from the lid.

4. Blow compressed air through the filter cartridge from the inside to the outside of the

filter. Replace the filter cartridge if it shows signs of wear.

5. Wipe down the gasket and lid mating surfaces to ensure a good seal. A good vacuum seal

is important for proper operation. Replace gasket if necessary.

6. Re-install the filter cartridge. Make sure the filter cartridge is properly seated in the

housing.

7. Use a new lock nut tightened to 15 foot pounds (20 Nm), and fasten the filter to the lid.

8. Place the hopper lid on the filter.

9. Close the toggle fasteners.

Spare Parts

Filter Cartridge: ID85612

Lock Nut: ID85486