17
4.3. Electrical Connection
Be safety conscious! High or low voltage can cause serious or fatal injury. Installation
must be performed by qualified personnel only. Always disconnect the power source
before attempting installation or repair.
Refer to local electrical codes, the schematic, and connection diagrams supplied with
this unit and the serial tag for wiring considerations. Run all wiring in conduit if codes
require it. Label all wiring to make any future troubleshooting easier. Make all
electrical connections tight.
Before connection to the electricity supply, ensure that the supply voltage and the power
frequency are in accordance with the data on the nameplate of the machine.
The main power disconnect must be freely accessible.
Ground the equipment against electrostatic charging.
4.3.1. XFC-K
Run electrical cable from the blowback valve to the conveying controller. Check control
schematics for proper terminal connection points.
