A SERVICE OF

logo

15
4.1. Installation
Use the following procedure to install the safety filter:
1. Place the safety filter in the conveying system directly before the vacuum pump.
2. Using 7/16”, Grade 5 or better hardware, secure the filter in place:
Wall Mount. Use the mounting flange to secure the filter to the wall.
Floor Mount. Bolt the floor stand to the ground.
Pump Mount. Bolt the pump and stand to the ground. Pump-mount is only available with
XPC pumps.
Note: Floor leg kits are available to convert a standard wall mount configuration to a
floor mount configuration. Part No. A0570013. Two (2) required per assembly.
Make sure all screws are strong enough to hold the weight of the filter.
3. Connect the vacuum line to the filter chamber’s inlet tube (A). Use a hose clamp to secure the
flexible hose.
4. Connect the vacuum pump line to the outlet tube (B). Use a hose clamp to secure the flexible
hose.
Installation
XFC-K XFC-A XFC-S XFC 225, XFC 1000