Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
23
38970
The following list is the procedure required to install
the Phillips head screw and tamper-resistant screws:
1. Remove the Phillips head screw from service
door (refer to Figure 19).
2. Remove two screws holding control panel to
control hood (refer to Figure 19).
3. Tilt control panel forward and lay on a protective
pad to prevent scratching of cabinet top.
4. Insert Phillips head screw down through double
“D” hole in left rear corner of cabinet top (inside
control hood) until it engages retainer nut located
on left rear corner gusset of cabinet (refer to
Figure 19).
5. Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten
screw. Torque of a power driver could over-tighten
screw causing damage to cabinet assembly.
NOTE: Tamper-resistant screws, bits and bit
holder are available as optional equipment at extra
cost.
6. Secure control panel to control hood using two
No. 8 tamper-resistant screws, Part No. 35528.
7. Remove two screws holding front panel to base
of washer and install two No. 12 tamper-resistant
screws, Part No. 35527.
Figure 19
Bit (No. 8 screws) Part No. 281P4
Bit (No. 12 screws) Part No. 282P4
Bit Holder (3/8 drive) Part No. 24161
Control Panel Tamper-Resistant Screw, Part No. 35528
Front Panel Tamper-Resistant Screw, Part No. 35527
Any disassembly requiring the use of
tools must be performed by a suitably
qualified service person.
W299
WARNING
W276I
1 35528 No. 8 Screws
2 Double “D” Hole
3 35527 No. 12 Screws
W276I
2
1
3