Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
38970
20
Water Supply Requirements
Water supply faucets must fit standard 19,1 mm
(3/4 inch) female garden hose couplings. DO NOT
USE SLIP-ON OR CLAMP-ON CONNECTIONS.
NOTE: Water supply faucets should be readily
accessible to permit turning them off when washer
is not being used.
Water Temperature
Cold:
Recommended cold water temperature is 10° to
24° Celsius, 50° to 75° Fahrenheit.
Hot:
Recommended hot water temperature is 60° to
66° Celsius, 140° to 150° Fahrenheit.
Warm:
Mixture of hot and cold water. (Warm water
temperature is dependent upon the water temperature
and the pressure of both the hot and cold water supply
lines.)
IMPORTANT: Turn off water supply faucets after
check-out and demonstration. Owner should turn
off water supply whenever there will be an
extended period of non-use.
NOTE: Longer inlet hoses are available (as
optional equipment at extra cost) if the hoses
(supplied with the washer) are not long enough for
the installation. Order hoses as follows:
No. 20617 Inlet Hose (2,44 m) (8 feet)
No. 20618 Inlet Hose (3,05 m) (10 feet)
Figure 16
Water Pressure
Pressure must be a minimum of 138 to 827 kPa
(20 to a maximum of 120 pounds per square inch)
static pressure measured at the faucet.
NOTE: Water pressure under 138 kPa (20 pounds
per square inch) will cause an extended fill time in
the washer.
Under certain conditions, hydrogen gas
may be produced in a hot water system
that has not been used for two weeks or
more. HYDROGEN GAS IS EXPLOSIVE. If
the hot water system has not been used
for such a period and before using the
washer, turn on all hot water faucets and
let the water flow from each for several
minutes. This will release any
accumulated hydrogen gas. The gas is
flammable. Do not smoke or use an open
flame during this time.
W029
WARNING
W293I
1 Water Inlet Hoses
2 Cold Water Connection
3 Hot Water Connection
W293I
2
1
3
WATER
MIXING
VALVE