Sharp HT-CN300W Washer User Manual


 
8
HT-CN300W_A_2.fm02/7/11
HT-CN300W
Connections
- Speaker / Aerial / Remote control sensor connections -
The speaker terminals on the main unit, the tube and plugs of the speaker lead, and
speaker labels are distinguished by colour.
Connect the speaker and the unit by matching the colours.
Connect the speaker wires to the speakers first, then to the unit.
Speaker
Main unit
Caution:
z
Only the supplied speakers should be used with this unit.
z
Make sure to connect the speakers after unplugging the unit.
z
Do not mistake and , and right and left terminals of the speaker leads.
z
Do not stand or sit on the speakers. You may be injured.
z
Insert the speaker plug fully with the rising side facing up.
z
Hold the speaker plug when removing it from the unit. Pulling the lead may cause
breakage.
Aerial connection
Position the FM aerial wire and rotate the AM loop aerial for optimum reception.
Place the AM loop aerial on a shelf, or attach it to a stand or on a wall with screws
(not supplied).
Notes:
z
Placing the aerial on the unit, or near the AC power lead or the remote sensor may
cause noise pickup. Place the aerial away from the unit for better reception.
z
Do not connect the attached FM aerial to an external FM aerial. Otherwise, trouble
may occur.
Installing the AM loop aerial:
Remote control sensor connection
Caution:
z
Hold the connection plug of the remote control sensor when removing it from the
unit. Pulling the lead may cause breakage.
z
Make sure of the top and bottom of the plug when plugging in the remote control
sensor.
z
Do not let the bare speaker wires touch each
other.
Label
Tube
Black
Red
Recess
Label
Speaker plug
Plug in with the rising
side facing up.
Connect the FM/AM loop aerial to
the ANTENNA socket.
< Assembling > < Attaching to the wall >
Connect the plug of the remote
control sensor and push the plug
cover until it clicks.
Removing the remote control sensor:
Push the upper and lower sides of the plug cover and take the
plug off the unit to disconnect the remote control sensor.
Screws
(not supplied)
Wall
Plug cover
Plug
Push
Push