Sharp HT-CN300W Washer User Manual


 
20
HT-CN300W_A_3.fm02/7/11
HT-CN300W
Remote Control
- Memorising the remote control buttons -
Memorising the remote control buttons
You can assign only one function to each button. If you assign two functions to the
button, the newer one will be memorised (learn function).
Memorising operations in the Memory 2
buttons for other equipment
The same buttons are used for both Memory 1 and 2 operations. To store signals in
Memory 1 buttons, set the MEMORY 1/2 selector switch to MEMORY 1, and for
Memory 2 buttons, set the switch to MEMORY 2.
Notes:
z
You cannot store all the button operations by pressing only one button on the
remote control of other equipment. Memorise them one by one.
z
After storing operation is completed, check that other equipment works correctly
with the remote control.
z
Some functions cannot be memorised depending on other equipment.
1
Set the MEMORY 1/2 selector switch to MEMORY 2.
2
Move the LEARN/TRANSMIT selector switch to LEARN.
The red learn indicator will light up. Though the red and green learn indicators
light up alternately after approx. 15 seconds, you can go on to the next step.
3
Press down the desired button on the remote control for 2 seconds
or more.
The green learn indicator will flash (the red indicator remains lit).
Lights up Alternately light up
Lit Flashes
4
Within 10 seconds, press down for more than 2 seconds the
desired button on the remote control supplied with other
equipment to send the signal to the marking.
When the signal is sent to the remote control of the unit, the green indicator will
go off. When memorisation is completed, it will light up.
If the signal is not memorised correctly, the
red learn indicator will flash. Perform the
operations from step 3 again.
5
Repeat steps 3 and 4 to memorise other buttons.
6
After memorisation is completed, move the LEARN/TRANSMIT
selector switch to TRANSMIT.
You can use the remote control.
10˚
Angle and distance
5 cm - 10 cm (2" - 4")
mark
Goes offLit Lit Lights up
Flashes