Sharp HT-CN300W Washer User Manual


 
13
HT-CN300W_A_3.fm02/7/11
HT-CN300W
Connections
- Connecting to the AC socket -
Connecting to the AC socket (continued)
Setting the FM/AM span selector
The International Telecommunication Union (ITU) has established that member
countries should maintain either a 10 kHz or 9 kHz interval between broadcasting
frequencies of AM stations and 100 kHz or 50 kHz for FM stations. The illustration
shows the 50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
Before using the unit, set the SPAN SELECTOR switch (on the rear panel) to the
interval (span) of your area.
To change the tuning zone:
Caution:
This operation will erase all data stored in memory and restore various settings to the
initial status (default).
Demonstration mode
The first time the unit is plugged in, the unit will enter the demonstration mode. You
will see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by mode (demonstration mode), press the X-
BASS button. The demonstration mode will be cancelled and the display will
disappear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the X-BASS button again.
Note:
When the power is on, the X-BASS button can be used to select the extra bass mode
(see page 23).
To turn the power on
Press the ON/STAND-BY button on the main unit or the ON/ (STAND-BY) button on
the remote control.
To set the unit to stand-by mode:
Press the ON/STAND-BY button on the main unit or the ON/ (STAND-BY) button on
the remote control again.
Notes:
z
For the operation range and direction of the remote control, see page 16.
z
When turning on the power right after it is set to the stand-by mode, wait a few
seconds.
1 Unplug the unit.
2 Set the SPAN SELECTOR switch (on the rear panel) as follows.
z
For 50 kHz FM interval (9 kHz in AM) 50/9
z
For 100 kHz FM interval (10 kHz in AM) 100/10
3 Plug in the AC power lead.
Power indicator