Sharp HT-CN300W Washer User Manual


 
23
HT-CN300W_A_4.fm02/7/11
HT-CN300W
Basic Operation
- Display control / Sound control -
Display control
To change the display brightness (2 levels)
You can switch the brightness of the main unit display by pressing the DIMMER
button.
TV screen display
By pressing the DISPLAY button whilst in the DVD or VIDEO mode, you can check
the status or setting on the TV screen.
Caution:
This unit can display on the TV its current speaker and mode settings when in the
DVD or VIDEO mode, but not if connected to the TV via an S-video cable. This
function is only available via the Video cable connection.
Sound control
Volume control
Press the VOLUME button to increase the volume and the VOLUME button for
decreasing.
Bass control
When the X-BASS button is pressed, the unit will enter the extra bass mode which
emphasises the bass frequencies. To cancel the extra bass mode, press the X-BASS
button.
Equaliser
When the EQ button is pressed, the current mode setting will be displayed. To
change to a different mode, press the EQ button repeatedly until the desired sound
mode appears.
Note:
Bass control and equaliser are enabled only when the sound mode is set to
"STEREO" or "VIRTUAL" (see page 26).
Dimmed (Dimmer mode) Brightened
Example: TV screen display
Bass frequencies are
emphasised.
Cancelled.
FLAT The sound is not modified.
ROCK Bass and treble are emphasised.
POPS Bass and treble are slightly emphasised.
JAZZ Treble is cut a little.
CLASSIC Treble is reduced a lot.
VOCAL Vocals (midrange tones) are emphasised.
210 29 30 MAXIMUM
.....
Main unit
TV screen
Main unit
TV screen