Sharp HT-CN300W Washer User Manual


 
28
HT-CN300W_A_4.fm02/7/11
HT-CN300W
Basic Operation
- Listening to a memorised station -
Listening to a memorised station
Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a
button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours should there be a
power failure or the AC power lead disconnection.
To recall a memorised station
To scan the preset stations
The stations saved in memory can be scanned automatically. (Preset memory scan)
To erase all the contents of the preset
memory
1
Perform steps 1 - 3 in "Listening to the radio" on page 27.
2
Press the MEMORY button to enter the preset tuning saving mode.
3
Within 30 seconds, press the or button to select the preset channel
number.
z
Store the stations in memory, in order, starting with preset channel 1.
z
When " " is displayed, a station has already been stored in memory.
4
Within 30 seconds, press the MEMORY button to store that station in
memory.
If the "MEMORY" and preset number indicators go out before the station is
memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset station.
When a new station is stored in memory, the station previously memorised will be
erased.
Press the or button to select the desired station.
Preset channel Frequency and frequency band
1
Press the or button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be tuned in
sequentially, for 5 seconds each.
2
Press the or button again when the desired station is located.
1 Press the TUNER/BAND button.
2 Hold the CLEAR button down for 3 seconds or more.
3 Whilst "CLEAR" is flashing, press the ENTER button.