Filter
Top Products
– The wash programme stops and a fault indicator light comes
on.
Fault indicator Possible cause Remedy 1
The buzzer sounds and
the Check drain light
flashes. “– – –”
appears in the display.
The water outlet is
blocked.
Clean the fluff (drain)
filter and drain pump.
The drain hose has been
fixed too high.
The maximum drain
height is 1 m.
The buzzer sounds and
the Check inlet light
flashes. “– – –”
appears in the display.
The water inlet is blocked. Open the stopcock.
The buzzer sounds and
the Check inlet and
Check drain lights
flash. “– – –” appears
in the display.
The Waterproof system
has reacted.
Call the Customer
Service Department.
The buzzer sounds and
the Soak/Pre-wash or
Rinses indicator light
flashes in the
programme sequence
display. “– – –”
appears in the display.
There is a fault. Start the programme
again.
If the fault indicators
occur again, contact the
Customer Service
Department.
1 To switch off the fault indicator: switch the washing machine off with the
I-ON / 0-OFF button and turn the programme selector to Finish.
Problem solving guide
44