Filter
Top Products
Top-up rinse for Cottons
When this is activated, additional
water flows into the drum at the end
of the main wash to cool the suds
down. Hot suds can damage plastic
drainage pipes.
Top-up rinse takes place when
temperatures of 95°C and 75°C are
selected.
Top-up rinse should be activated:
–
to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipes do not
comply with DIN 1986.
The washing machine is delivered with
the Top-up rinse for
Cottons
deactivated.
Follow steps A to G to programme
and store in memory.
Before you begin, first ensure that
:
–
The washing machine is switched off.
–
The drum door is properly closed.
A Press the
Start/Stop
button and keep
it pressed in whilst carrying out steps
B - C.
B Press the
I-On/0-Off
button in.
C Wait until the indicator light for the
Start/Stop
button comes on . . .
D . . . and then release the
Start/Stop
button.
E Press the
Buzzer
button twice.
–
The
Buzzer
indicator light will flash
three times.
A P will flash in the display alternating
with the number 0 or 1.
0 = Top-up rinse is deactivated.
1 = Top-up rinse is activated.
F Pressing the
Start/Stop
button will
change the display message from 0
to 1 (activated) or from 1 to 0
(deactivated).
G Switch the machine off with the
I-On/0-Off
button.
The setting you have selected is now
stored in memory and will remain so
until you alter it.
Programmable functions
60