Filter
Top Products
General problems
Problem Possible cause Remedy
The Excess detergent
CHECK light comes on.
Excessive foam has
built up during
washing.
Use less detergent next time
and follow the
manufacturer's instructions
on dosage given on the
packaging.
The Main wash
SEQUENCE indicator
light is flashing.
There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
The machine shakes
during the spin cycle.
The machine feet are
not level.
Level the machine (see
"Installation").
The pump makes
strange noises.
This is not a fault! These noises occur at the end of a
pump sequence as a normal part of the operation.
Large amounts of
detergent residue
remain in the detergent
dispenser drawer.
The water pressure is
too low.
– Clean the filter in the
water inlet.
– It may be useful to select
the
Water plus
Extra.
Powder detergent
used in conjunction
with water softeners
tends to become
sticky.
In future, add washing
powder into the dispenser
drawer first, and then add
the water softener.
Fabric conditioner is not
completely dispensed or
too much water remains
in the § compartment.
The siphon tube is not
correctly positioned,
or is clogged up.
Clean the siphon, (see
“Cleaning and care -
Cleaning the detergent
dispenser drawer”).
When laundry is dry it
feels hard to the touch.
Too vigorous wash
action.
Programme in gentle action
and more water.
Not enough detergent
used.
Increase detergent dose to
prevent limescale build up in
laundry.
No fabric conditioner
used.
Use fabric conditioner in last
rinse.
Cleaning and care
36