Filter
Top Products
The wash programme stops and a fault indicator light comes
on.
Problem Possible cause Remedy A
The buzzer sounds and
the Drain CHECK light
flashes. "– – –" appears
in the display.
The water outlet is
blocked or restricted.
Clean the fluff filter and the
drain pump as described in
"Problem solving guide –
Opening the door in the
event of a blocked drain
outlet or a power failure".
The drain hose has
been fixed too high.
The maximum drain height is
1 m.
The buzzer sounds and
the Inlet CHECK light
flashes. "– – –" appears
in the display.
The water inlet is
blocked or restricted.
Check whether
– the stopcock is opened
wide enough.
– the inlet hose is kinked.
The filter in the water
inlet hose is dirty.
Clean the filter.
The buzzer sounds and
the Inlet and Drain
CHECK light flash.
"– – –" appears in the
display.
The Miele Waterproof
system has reacted.
Call the Service Department.
The buzzer sounds and
the Soak or Rinses
SEQUENCE indicator
lights flash. "– – –"
appears in the display.
There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
A To delete the fault message: Switch the washing machine off with the
I-On/0-Off
button.
Cleaning and care
35