Filter
Top Products
2 printed in U.S.A.
PREINSTALLATION CONSIDERATIONS
Location: The stacked washer/dryer is approved
for zero clearance installation on the sides and
the back (depending on venting used). The loca-
tion selected must take into consideration the
dimensions of the unit and convenience for cus-
tomer use and access in case service should be
needed. The floor must be capable of supporting
the weight of the unit (approximately 310 lbs.)
plus water (approximately 150 lbs.) and be stable
enough to prevent excessive vibration in spin
cycles. A floor which is adequate for the
standard washer is sufficient for the stacked
washer/dryer.
The following specifications and drawings show
dimensions and locations of fill valve, terminal
block (electric dryer), gas inlet (gas dryer) and
drain outlet.
STACKED WASHER AND DRYER
Basic Dimensions: 27
1
/
2
W x 27
1
/
2
D x 73 H (min.) See drawings for complete dimensions.
Uncrated Weight: Approximately 310 lbs.
KEY FACTS – WASHER
Capacity: Standard (16 gal.)
Water Usage: (full cycle)
36 (30 Imp.) gal.; 136 liters – large
28 (23 Imp.) gal.; 106 liters – medium
22 (18 Imp.) gal.; 83 liters – small
Motor: 1/2 H.P. rated; 120 volt; 60 Hz; reversible, thermo-
protected against overload; automatic reset.
Power: .1 – .17 kwh depending on cycle
Hose Lengths: Inlet 4.0 feet, drain 4 feet
Installation Requirements: Hot and cold connections
with water pressure within 20 – 120 PSI range. At
least 140°F. hot water and a drain.
KEY FACTS – DRYER
Air Flow: 180CFM
Exhaust: 4″ duct permits up to a maximum of 50 feet rigid
aluminum ductwork. Subtract 8 feet for each 90°
elbow, 8 feet for an exhaust hood. Dryer vented
out the back.
Motor: 1/4 H.P. rated; 115 volt; 60 Hz thermoprotected
against overload; automatic reset.
Heat Source: Electric-Nichrome helix coil, 240 volt 3-wire,
4600 watts, (4500 wats for Canadian models
only), 30 amp fuse. Gas-single port burner 18000
BTU/hr.; electric ignition; automatic shut-off.
Capacity: 4.7 cu. ft., .13 cu. m.
Drum Speed: Approximately 47.5 RPM
Electrical Requirements: Electric Dryer – 240 volt 60 Hz
protected by a 30 amp fuse. Gas Dryer – 115
volt electrical outlet properly grounded and
protected by a 15 amp fuse.
DIMENSIONS
INSTALLATION SHOWING
GAS DRYER CONNECTION
INSTALLATION SHOWING
ELECTRICAL/WATER/DRAIN BOX
BEHIND WASHER-ELECTRIC DRYER