Filter
Top Products
10 printed in U.S.A.
DRYER INSTALLATION
ACCESSORIES
Vent Kit – standard – 4″ (10.16cm)
kit includes two elbows, three pipes and
one vent hood
Vent Hood – 4″ (10.16cm) opening
Aluminum Pipe – 4″ x 24″ (10.16cm x 60.96cm)
Aluminum Elbow – 4″ (10.16cm)
Aluminum Window Plate – 15″ x 20″
(38.10cm x 50.80cm) – 4″ (10.16cm)
Flexible Vent Kit – contains wide opening vent
hood, wall plate, two clamps and flexible
aluminum vent duct
Flexible Aluminum Vent Duct – 4″ (10.16cm)
diameter – 38″ (81.28cm) length stretches
to 8′ (2.44m)
Clamp for Flexible Aluminum Duct
Exhaust Deflector Kit – inside exhaust kit
Natural to LPG Conversion Kit for Gas Valve
Dacron Lint Bag
Grounding Kit – contains ground wire, clamp,
ground screw and washer
(Part No. 12001875)
INSTALL WASHER UNIT
1.
Remove top cover
shipping pads
taped to washer
top.
2. Remove fill
hoses.
Replace and
leave tub
block in place
until installation is
complete. Close lid.
3. Remove the crate
base wires from
crate base. Use
pliers or screw-
driver to pry from
wood. Discard crate
base.
4. Run washer rear legs all the way up into
the rear corner brackets. Lock in place by
tightening lock nuts up against base.
Leave front legs loose for leveling later.
Install the vinyl feet on the front washer legs.
5. Move the washer into position in front of
the dryer and stand. Use caution to avoid
floor damage because of the minimum
height of the rear legs.
NOTE: Before sliding washer back into
position, connect fill hoses and insert drain
hose in standpipe.
6. Install inlet hoses.
Run water through both water
faucets into a bucket to purge
the water line particles that
might clog the hoses. While
running water through the
faucets, determine which
faucet is HOT water and
place an identifying mark
on it. Traditionally the HOT water faucet is
on the left.
Insert one screen and
then one washer into the
faucet ends of the inlet
hoses (straight end of
hoses). The screens
should be pointing
out to fit properly.