Filter
Top Products
12 printed in U.S.A.
10. Connect the dryer power cord to 120 volt
AC outlet for gas models. 240 volt outlet
for electric models.
Make appropriate external ground
connection. See DETAILED Installation
Instructions for
ELECTRICAL
REQUIRE-
MENTS AND
GROUNDING
(pages 6-7).
11. Slide washer all the way back into stand.
Tabs on stand legs are to slide into the
washer front panel. Adjust the washer
front legs. Level washer on stand. Lock
leveling legs in position using lock nuts.
It is very IMPORTANT
that the washer sits in
the stand
properly. Unit
must be solid
and level.
Check unit to
finish leveling.
Be sure to lock
ALL leveling
leg lock nuts.
12. • Remove tub block ring from washer tub
opening.
• Verify that all instruction packages have
been removed from washer tub and
dryer drum.
• See Installation Checklists for washer
and dryer.
DRYER INSTALLATION CHECK LIST
■■ Dryer is plugged into electrical outlet and
is properly grounded.
■■ Exhaust duct work is hooked up and
joints taped.
■■ Plastic flexible duct is NOT used.
■■ Use rigid or stiff-walled flexible metal vent
material.
■■ Dryer is level with all legs firmly on the
floor, with the lock nuts tightened.
■■ Vinyl feet have been installed.
■■ Gas Models – gas is turned on, there are
no gas leaks.
■■ Dryer runs, heats, shuts off.
■■ Demonstrate use to consumer.
WASHER INSTALLATION CHECK LIST
■■ Tub block, parts package and instruc-
tions have been removed from the tub.
■■ Water has been turned on. Checked
for leaks at faucets and water valve
connections.
■■ Drain hose is properly located into
drain facility and is not damaged.
■■ Washer has been leveled with legs
firmly on the floor. The front leveling
legs’ locking nuts have been tightened.
■■ Fill washer, checking for the correct
water temperature.
■■ After the washer has filled, let the
washer agitate.
■■ Spin the water out.
■■ Demonstrate washer usage to consumer.
Be sure to leave these instructions and
the User’s Guide with the owner.
WASHER INSTALLATION ACCESSORY KITS
Part No. Description Application
12001875 Grounding Kit Contains ground wire, clamp, ground screw and washer.
12001585 Drain Hose Extension Extends drain hose for drain facilities higher
than 1.2 m (4 ft.).
12001586 Siphon Break Used when an air-tight connection exists between
drain hose and drain facility. Floor drain facilities.
12001599 Small Diameter Standpipe Used when standpipe diameter is too small to
Drain Hose receive end of drain hose.
211692 Non-Slip Disc For painted /sloped floors.
204986 Carpet Installation Disc For carpeted floors.