Filter
Top Products
printed in U.S.A. 9
INSTALLATION
INSTALL DRYER UNIT AND STAND
The dryer and stand are installed first. With the
connections prepared for exhausting, electric
power and gas (if gas stacked washer/dryer, see
page 9), the dryer and stand are moved to the
location.
NOTE: When moving the dryer and stand on an
appliance hand truck, it is recommended that the
dryer and stand be trucked upside down.
Protective padding should be used to avoid
damage to the cabinet finish.
1. Grasp the dryer and
stand. Pull away from
washer and off of
shipping base. Install
vinyl feet; in
Accessory Package
located in Washer.
Move dryer and stand
to location. Level by
adjusting leveling legs.
NOTE: The rear legs are “washer” legs
and use the larger feet.
2. GAS MODELS -
Connect gas line
using pipe joint
compound on
male threads, see
page 9 for GAS
CONNECTION.
See DETAILED Installation Instructions for
ELECTRICAL REQUIREMENTS AND
GROUNDING (pages 6-7).
3. Make exhaust
connections.
Exhaust connection
is lined up as the
dryer and stand are
moved back into
position.
See DETAILED
Installation
Instructions for
EXHAUSTING
(pages 4-6).
4. Adjust stand and
dryer into proper
location. Check
stand to make
sure unit is still
level. Level legs
and rear lower cross
bar. Tighten lock
nuts up against the
stand.
With dryer and stand in position, exhaust
vent connected, unit leveled and gas line
connected (if gas unit), power cord set
installed (if electric unit), plug power cord
into electric outlet.
ELECTRIC MODELS -
Install electric power
cord (U.L. Approved).
NOTE: Power cord
provided with
Canadian models.
Make appropriate
external ground
connection.