Filter
Top Products
Problem Possible Cause Solution
Dryer Will Using a regularfuse. Replace with a time-delayfuse.
Not Run Dryer doornot firmly closed. Close dryer door tightly.
(con't)
PUSH TO START Button Press PUSH TO START Button again.
not firmly pressed.
Controls not set in an Reset controls in an ON position.
ON position.
Lint in Load Lint screen is clogged. (;lean lint screen. Check for air
movement.
Improper sorting. Sort lint givers from lint takers
and by color.
Load is too big or heavy. Dry smaller loads so lint can be
carried to the lint screen.
Load is overdried. Use correct dryer settings for fabric.
Overdrying can cause lint-attracting
static (see "OPERATION").
Paper or tissue in pockets. Clean out pockets before drying.
Pilling being mistaken for lint. Pilling (surface fuzz) is caused by
normal wear and laundering.
Stains on Load Improper use of fabric softener Use fabric softener sheets in dryer. Add
in washer, at beginning of cycle when load is cold.
Drying soiled items. Items need to be clean before
being dried.
Items Overdrying. Match dryer settings to fabric type
Sh rinking (see "OPERATION").
Poor garment quality. Check quality of garment before
purchasing.
Manufacturer's care label Follow fabric care label instructions
instructions not followed, carefully.
Loads are Overloading. Dry smaller loads that can tumble freely.
Wrinkled Overdrying. Match dryer settings to fabric type
(see "OPERATION").
Remove load as soon as tumbling
stops.
Do not use dryer while these chemical
fumes are in the air.
Load left in dryer at the
end of cycle.
Odors Household chemicals, paint,
or vamiish beingdrawn
into dryer.
Firstuse ofdryerelement Will be gone after the first cycle.
(electrk" only).
Unusual Whistle - blocked lint screen Clean lint screen.
Sounds causes Lint Alert to activate.
Thumping of rollers when Thump will go away after 5 minutes
dryer has set. of drying.
z
i
t
39