Filter
Top Products
CHECKING FOR AIR FLOW
OBSTRUCTION
From time to time, you may find it helpful
to check your dryer and exhaust system
for proper air flow. Poor air flow can
result in longer drying times.
To check for air flow obstruction:
STEP 1. Check to ensure nothing is
blocking ventilation slots on dryer rear
panel.
STEP 2. Inspect exhaust hood. It should
not be blocked or obstructed.
To remove accumulated lint from
inside the dryer:
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all panels before operating.
Failure to follow these instructions
can result in death ,or electrical
shock.
REMOVING ACCUMULATED LINT
Lint can gather inside the exhaust
vent or dryer and be a fuel for fire. Lint
should be removed every 2 to 3 years, or
more often, depending on dryer usage.
Cleaning should be done by a qualified
service person.
To remove accumulated lint from
exhaust vent:
STEP 1. Disconnect exhaust vent from
the dryer.
STEP 2. Clean one section of vent at
a time until your reach the exhaust hood.
To clean out lint, you can use the hose
attachment on your vacuum or, use a
pole or wire with a feather duster or rag
attached.
STEP 3. Reconnect vent as described in
the "INSTALLATION INSTRUCTIONS" of
this Owner's Manual.
STEP 1. Unplug the power supply cord
or turn off the electrical power supply.
STEP 2. Remove lower front panel by
releasing 2 locking clips with a putty
knife. The clips are located 4 inches in
from each side of the top of the lower
front panel.
PuEttyknife
STEP 3. Remove lint from the dryer base
with a soft brush or vacuum cleaner. Avoid
damaging wires or electric thermostats.
STEP 4. Replace lower front panel;
reconnect and level dqter again,
if necessary.
36