Filter
Top Products
CHANGING THE DRUM LIGHT
The dryer light automatically turns on
inside the dryer drum when you open
the door.
To replace bulb:
STEP 1. Unplug power supply cord or
turn off electrical power supply.
STEP 2. Open the dryer door. Remove
the screw that holds the lens in place.
STEP 3. Remove the lens by pulling
it down and away from drum.
STEP 4. Push tab to allow bulb to
swing out.
STEP 5. Check that the light bulb is
screwed in tightly. The vibration of the
dryer may cause the bulb to come loose.
If this is not the problem, remove the
light bulb by turning it counterclockwise.
IMPORTANT: Replace the bulb with
a 25-watt, 120V A.C. bulb only.
STEP 6. Install light bulb by turning it
clockwise.
STEP 7, Push bottom of light and socket
assembly in until tab locks.
STEP 8. Place the top of the lens onto
the top of the holder. Rotate the bottom
of the lens down until it is in place.
Replace screw. NOTE: It is very impor-
tant that the lens is replaced properly.
STEP 9. Plug in power supply cord or
turn on electric supply.
MOVING CARE
• Unplug power supply cord or turn
off electrical power supply.
• Make sure leveling legs are secure
in dryer base.
• Use masking tape to secure dryer
door.
VACATION CARE
• Unplug power supply cord or turn
off electrical power supply.
• Wash lint screen.
37