Filter
Top Products
GREEN & YELLOW
BROWN
CORD CLAMP
BLUE
If you fit your own plug, the colours of the
wires in the mains lead of your appliance may
not correspond with the markings identifying
the terminals in your plug.
Proceed as follows:
1. Connect the Green and Yellow (earth)
wire to the terminal in the plug which is
marked with the letter "E" or the earth
symbol
or coloured green and yellow.
2. Connect the Blue (neutral) wire to the
terminal in the plug which is marked with
the letter "N" or coloured black.
3. Connect the Brown (live) wire to the
terminal in the plug which is marked with
the letter "L" or coloured red.
4. Upon completion there must be no cut,
or stray strands of wire present and the
cord clamp must be secure over the outer
sheath.
Warning! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard.
Ensure that the cut off plug is
disposed of safely.
Warning! The plug must still be
accessible after the appliance
has been installed.
Warning! The appliance should
not be connected to the
electrical supply by means of an
extension cable.
Warning! The manufacturer
declines any responsibility for
damage or injury through failure
to comply with the above safety
precautions.
Should the appliance power
supply cable need to be replaced,
this must be carried out by our
Service Centre.
Warning! The power supply
cable must be accessible after
installing the machine.
Permanent connection
In the case of permanent connection it is
necessary that you install a double pole switch
between the appliance and the electricity
supply (mains), with a minimum gap of 3mm
between the switch contacts and of a type
suitable for the required load in compliance
with the current electrical regulations.
The switch must not break the yellow and
green earth cable at any point.
Door reversal
To make it easier to load or unload the
laundry, the door can be reversed.
Warning! The door must only be
reversed by an authorised service
engineer.
27