Filter
Top Products
Displayed programme time
changes erratically or stays
unchanged for a long time.
Programme time is corrected
automatically depending on type
and volume of laundry and level
of dampness.
Automatic process; this is not a
machine fault.
Programme inactive, empty
water tank warning lamp Full
tank lights.
The water reservoir is full.
Empty the water reservoir, then
start programme with Start/
Pause button.
Drying cycle ends shortly after
programme starts. END display
illuminated.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Select time programme or higher
drying level (e.g. INTENSIVE
DRY instead of STORAGE
DRY).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends
automatically (see „Drying cycle
complete ”).
Lint filter clogged. Clean lint filter.
Fluff filter clogged. Clean fluff filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Particularly high room
temperature. Temporary
switching off of the compressor
to avoid overload.
Automatic process, there is no
fault with the appliance. If
possible, lower the room
temperature.
Replacing the drum light
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force
Centre.
Important! When the appliance is switched
on, the interior lighting switches itself off after
4 minutes when the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Warning! Before replacing the bulb,
disconnect the mains plug; with a
permanent connection: fully unscrew
or deactivate the fuse.
1. Unscrew the cover above the bulb (this
can be found directly behind the loading
aperture, at the top; refer to “Description
of machine” section.)
2. Replace the defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket
before screwing back the door light cover. Do
not operate the dryer when missing o-ring
gasket on door light cover.
Warning! For safety reasons, the
cover must be screwed down tightly.
If this is not done, the dryer must not
be operated.
22