Filter
Top Products
What to do if ...
If, during operation, the error code E... plus
number or letter) appears on the LCD: Switch
the machine off and on again to reset the
programme. Press the Start/Pause button If
the error is still displayed, please inform your
local Service Force Centre and quote the
error code.
Problem Possible cause Remedy
Dryer does not work.
Mains plug is not plugged in or
fuse is not working correctly.
Plug in at mains socket. Check
fuse in fuse box (domestic
installation).
Loading door is open. Close loading door.
Have you pressed the Start/
Pause button?
Press the Start/Pause button
again.
Drying results unsatisfactory.
Wrong programme selected.
Select a different programme the
next time you dry (see
“Programme chart” chapter).
Lint filters clogged. Clean lint filters.
Fluff filter clogged. Clean fluff filter.
Overloading of laundry.
Observe recommended loading
volumes.
Ventilation slots in base area
covered up.
Uncover ventilation slots in base
area.
Residue on inside surface of
drum or drum ribs.
Clean inside surface of drum and
drum ribs.
Make an adjustment using the
DRYNESS function (see
chapter ”Daily use”)
Loading door does not close.
Fine strainer not in place and/or
mesh filter not locked in place.
Install fine strainer and/or snap
large mesh filter into place.
When a button is pressed, Err
appears on the LCD.
Washing protection. After the
start of the programme, the
option can no longer be set.
Turn the programme knob to
Off. Set the programme again.
Drum light does not work.
Programme selector in Off
position.
Turn programme selector to
LIGHT or to any programme.
Defective light bulb.
Replace light bulb (see next
section).
21