Filter
Top Products
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob, the programme
progress display and the maintenance
indicators flash. If an option button
(excluding the Alarm button) is
pressed, Err appears in the
multidisplay.
The drying programme is not however
affected by this (laundry protection).
Putting in extra items or
taking items out before
end of programme
1. Open loading door.
Warning! Laundry and drum can
become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly
lock.
4. Press the Start/Pause button to continue
the drying cycle.
Drying cycle complete /
removing laundry
Once the drying cycle is complete, the display
shows the anti-crease icon and flashing "0" as
well as warning lamps: Filter and Full tank. If the
Alarm button has been pressed, an acoustic
signal sounds intermittently for about one
minute.
The drying cycles (except from the
Wool programme) are automatically
followed by an anti-crease phase
which lasts around 30 minutes. The
drum rotates at intervals during this
phase. This keeps the laundry loose
and free of creases. The laundry can be
removed at any time during the anti-
crease phase. (The laundry should be
taken out towards the end of the anti-
crease phase at the latest to prevent
creases from forming.) If Long anti-
crease function has been selected, the
anti-crease phase is lengthened by 60
minutes.
1. Open door.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use
a damp hand for this purpose. (See
“Maintenance and cleaning” chapter.)
3. Remove laundry.
4. Turn the programme selector to Off.
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter “Maintenance and
cleaning ”.)
5. Close the door.
15