Filter
Top Products
Removing transport
safety packaging
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading door
2. Pull off adhesive strips from inside
machine on top of drum.
3. Remove foil hose and polystyrene padding
from the machine.
Warning! If the appliance was not
transported in an upright position,
leave it to stand for 12 hours before
connecting it to the electricity supply
and using it for the first time, so that
the oil can flow back to the
compressor. Otherwise the
compressor could be damaged.
Electrical connection
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
Warning! THIS APPLIANCE
MUST BE EARTHED.
Should the appliance power
supply cable need to be replaced,
this must be carried out by a
Service Force agent (see
chapter: Repairs - after sales
service).
The manufacturer declines any
liability should this safety
measure not be observed.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the appliance’s rating plate. (See picture on
page 6).
The appliance is supplied with a 13amp plug
fitted. In the event of having to change the fuse
in the plug supplied, a 13amp ASTA approved
BS 1363/A fuse must be used.
Should the plug need to be replaced for any
reason, proceed as described below. The
wires in the mains lead are coloured in
accordance with the following code:
• Green and Yellow - Earth
•Blue - Neutral
•Brown - Live
26