Hitachi AJ-S65KXP Washer/Dryer User Manual


 
9
How to Install the Water Drainage Hose
(AJ-S70KXP, AJ-S65KXP)
Fully insert it into place to avoid leakage.
Water Drainage Hose
Water Drainage Joint
Hose Clipper
To avoid direct draining due to the fallen water drainage hose, the water drainage
hose must be used only after installing into fixing holder and its hanging height
should not exceed 1m.
1
Do not release the water drainage hose lest the water is splashed.
Do not use extended water drainage hose.
Do not immerse the U-shaped hose on the tail of the water drainage hose in the water.
U
When using it in winter, to prevent icing, please release the water drainage hose
after using and place the its tail in water container such as basin, set the washer to
single dehydration mode and drain the remained water.
44
44
Be sure not to install the water drainage hose at a position lower than water
drainage joint, otherwise, it could lead to difficulties in water drainage.
2
After the connection is completed, please
use hose clipper to clamp the water
drainage hose to avoid fall-off.
1
Connect the water drainage hose with the
water drainage joint on the back of the
body.
34
1Insert the fixing holder of
water drainage hose into
mounting hole.
2As shown in illustration,
rotate the fixed leg for 90
degree into hole.
90
Pull the water drainage
hose straight, concave
to fix into the fixing
holder of water
drainage hose.
1Insert
2Rotate
Fixing
holder
1m
Water drainage
hose
Unplug U-shaped
hose and insert
into water
drainage hose.
U
Concave
Attention
This discharge pipe installs the method to be only suitable in AJ-S70KXP, AJ-S65KXP
AJ-S70KXP, AJ-S65KXP