Filter
Top Products
13
1
3
2
2
1
Please turn on the water tap to check to connecting condition of the water supply hose
before washing.
To prevent damages caused by water leakage due to loosen screw.
How to install and remove the water supply hose
Water tap
Do not allow water tap, one touch joint and rubber
ring to touch the unit when installing them.
Installing
Push down the rubber ring
and insert the tap into the
one touch joint.
Release the rubber ring and
push up the water supply
hose until it clicks.
Pull the water supply hose to
check that it does not come
off easily.
Removing
Turn off the water tap.
Press the start button and let the unit run for about
ten seconds.
10
This is to prevent water splash when removing the tap.
Remove the latch and the water supply hose while
pushing down the rubber ring.
Loosely tightened union nut will cause water
leakage.
When removing the hose, unscrew the union
nut first.
Please note that water supply hose and one
touch joint should be used.
Turn the union nut in the direction as shown
by the arrow and firmly. Connect it to the
water supply opening.
Firmly tighten the union nut when con-
necting the water supply hose to the main
unit.
Failure to do so may result in water
leakage.
Installation
Attention
Attention
One touch joint
Latch
Latch
Water supply hose
Rubber ring
Rubber ring
Turn off
Union nut
Attention
Main unit
The appliance is to be connected to the water
mains using new hose-sets and that old hose-
sets should not be reused.