Filter
Top Products
12
How to Install the One Touch Joint
1
Confirm the diameter of the water tap.
Distance must be over 1.6cm
in order to install correctly.
1.6cm
May break off after install
the one touch joint.
Water leakage may
occur.
If the diameter exceeds 2cm, remove
the joint ring.
2cm
Screw joint B in the arrow direction to
adjust the gap.
B
For water supply hose installation, please refer to "How to install the water supply hose" in the user manual.
Loosening may occur with extended use. In such case, reinstall the joint following steps 2 to 4.
2 ~ 4
(Carry out the same steps when reinstalling the one touch joint at a change of residence, etc.)
( )
Horizontal tap A
A
Horizontal tap B
B
Square mouth tap Universal household tap Swivel tap
2
3
4
Tighten joint B in the arrow direction
to reduce the gap between joint A
and B to 4mm or less.
B A B
4mm
Screw
Label
One touch joint
Joint ring
Check the distance between
joints A and B.
A B
Joint
Approximately
Joint
6mm
6mm
Press the sealed pad evenly against the
tap and tighten the four screws in a uniform
fashion.
4
Tighten screw in advance if it is
located close to the wall.
Water tap
Sealed pad
Joint
Joint
Joint
4
4
(After tighten)
Less than
Appropriate water tap
Horizontal taps A and B as shown below.
A B
Installation Guide (continued)