Filter
Top Products
- 87 -
RECYCLE
In the Control Option mode, similar to setting the RESTART. Push the button beside the word
RECYCLE to toggle on and off Recycle. At the end of servicing, Smartdrive may require an extended
test where it can be left to complete a number of wash cycles. By turning on RECYCLE Smartdrive will
continuously repeat the selected wash cycle until RECYCLE is turned off.
The status of RECYCLE is indicated during normal use when Smartdrive is first turned on:
If none of the FABRIC CARE LED’s are on, recycle is off.
If all of the FABRIC CARE LED’s are flashing, recycle is on.
NB: Recycle is designed as a service aid only and should be OFF in the customer’s home. To return to
normal operation, and to return recycle to the default setting, switch Smartdrive off at the wall. If this does
not reset the state then RESTART and RECYCLE must be reset in EEPROM. To set these states hold
down the button adjacent to the LCD for 2 seconds, Smartdrive will beep once.
HOT BOWL FLAG
If Smartdrive has been filled with hot water and has not had a cold rinse, Smartdrive will not spin up to its
full speed of 1000 RPM, its maximum speed will be reduced to 700 RPM. To remove this flag, enter the
Control Option mode and push the button beside the words HOT BOWL CLEAR, or put Smartdrive
through a complete final rinse.
NB: The drain pump test, water valve test, restart, recycle and hot bowl flag can be accessed from any
level in the diagnostic mode.
E.6 SIZE SETTING MODE for IW
It is important to set the size of Smartdrive into the Motor Controller’s EEPROM whenever a replacement
Motor Controller or Display Module is fitted to Smartdrive. Failure to do so will result in fault code 9.
To set the size, turn the power on at the power point and off at the console. Press and hold the FABRIC
CARE button, then press the POWER button. This will give either of the following options in the LCD
screen.
IW509, IW609, IW709
‘size’ is determined in the conventional
way, with sizes 5, 6 & 7.
MACHINE SIZE SETUP
57
6 no size
IWC09, IWM10, IW710,
IWL10, IW810
‘size’ is determined by product width in mm.
MACHINE SIZE SETUP
560 650
600 no size
The LCD screen has a number of options. Pushing the button alongside the appropriate machine size, or
product width will select and highlight the size. Pushing the POWER button will set the “size” into the
module’s memory.