Filter
Top Products
- 65 -
14. Lay the cabinet on its back, on protective material, and slide the outer bowl assembly out, but note
that approximately 1 litre of water must be removed from the pump sump before laying the cabinet
on its back.
15. To remove the pump, release the locking
tab. Turn the pump anti-clockwise, lift it
clear and remove the electrical connections.
16. Remove the two screws securing the wiring
duct to the outer bowl base.
17. Remove the drain hose clamp. Twist the
drain hose in an anti-clockwise direction to
release the bayonet fitting. If changing the
outer bowl, the pump securing plate can be
removed at this stage by unscrewing the 4 x
3/8" securing bolts.
18. Remove the clamp from the pressure tube
and pull the tube off the spigot on the
pressure chamber.
19. Unclip the pump harness and then remove
the complete assembly.