Filter
Top Products
- 33 -
8.4 RESTART
If a problem occurs in Smartdrive, it will try to correct the problem and retry. Smartdrive will rectify any
problems of a temporary nature. If there is a continuous problem Smartdrive will retry several times. This
process may take up to 10 minutes depending on the type of problem. If Smartdrive still cannot resolve
the problem, the fault code is displayed and Smartdrive will beep continuously. RESTART ON is the
default state. This forces Smartdrive to retry when a problem occurs. While servicing Smartdrive turn
RESTART OFF. This will allow any fault in the system to show up immediately.
To enter Diagnostic Mode turn the power on at the power
point and off at the console. Press and hold the WASH
TEMPERATURE DOWN button then press the POWER
button. Smartdrive will give 2 short beeps. Phase 3 Only
press ADVANCE button once. From Diagnostic mode use the
WATER LEVEL DOWN button to turn the RESTART on
or off.
LOW WATER LEVEL LED OFF = RESTART OFF.
LOW WATER LEVEL LED ON = RESTART ON. (Default)
RESTART status can be easily identified when Smartdrive is first turned on -
• If none of the 5 leftmost green wash progress LEDs are on, the RESTART is on.
• If the 5 leftmost green wash progress LEDs are flashing, the RESTART is off.
NB. RESTART is a service aid only and should be left ON in the customer’s home. To return to normal
operation, and to reset the RESTART feature to the default setting, power off Smartdrive.
8.5 RECYCLE
After servicing, Smartdrive may require an extended test where Smartdrive can be left to complete a
number of wash cycles. By turning on RECYCLE Smartdrive will continuously repeat the selected wash
cycle until RECYCLE is turned off.
Enter Diagnostic mode as described above (RESTART). Use the WATER LEVEL UP button to turn
RECYCLE on or off.
MEDIUM WATER LEVEL LED ON = RE-CYCLE ON.
MEDIUM WATER LEVEL LED OFF = RE-CYCLE OFF. (Default setting).
RECYCLE status can be easily identified when Smartdrive is first turned on: -
• If the 3 rightmost rinse and spin progress LEDs are on, recycle is off.
• If the 3 rightmost rinse and spin LED’s flash, recycle is on.
NB. Recycle is designed as a service aid only and should be OFF in the customer’s home. To return to
normal operation, and to return recycle to the default setting, power off Smartdrive.