Filter
Top Products
- 29 -
FIRST RINSE OPTION (2) Spin only. Does not give as good a suds removal as Option (1) but
uses less water than Option (3)
FIRST RINSE OPTION (3) Deep Rinse. Gives better suds
removal but increases water usage.
The first rinse is always followed by a final deep rinse and spin. Method of
selecting RINSE OPTIONS
1. Select the OPTION ADJUSTMENT MODE by pressing and holding
the START/PAUSE button, then pressing the POWER button.
2. Press the SPIN SPEED buttons to select Rinse options. Hold LED ON
OPTION (1). Slow LED ON OPTION (2). Med LED ON OPTION (3).
3. To return Smartdrive to Normal operation, press the POWER button.
7.3 End of Cycle Warning Beeps (GW Only) – All Phases
Smartdrive finishes each cycle by sounding a series of warning beeps.
These beeps are designed to be noticeable. In some circumstances, e.g. shift
workers, new baby in the house, etc, the user may wish to increase the
number of beeps or eliminate them altogether. They may be adjusted as
follows:-
Select the OPTION ADJUSTMENT MODE by pressing and holding the
START/PAUSE button, then pressing the POWER button. Use the WASH
OPTIONS button and LEDs to select the required option. Pressing the WASH
OPTIONS button will cause the LEDs to change.
Phase 3-5 Time Saver LED on (Top) 15 beeps
Soak LED on (Middle) 5 beeps (default)
Water Saver LED on (Bottom) 0 beeps
Phase 1-2 Wash & Soak LED on (Top) 15 beeps
Time Saver LED on (Bottom) 5 beeps (default)
No LEDs on 0 beeps
To return Smartdrive to Normal operation, press the POWER button.