Filter
Top Products
- 35 -
9.0 SIZE SETTING MODE – Phase 4 and 5 only
Phase 1-3 sizes are determined by 2 switches on the display and protrusions on the console. When
replacing Display or Motor Controller enter Option Adjustment mode to set these sizes in EEPROM. To
check the size setting on Phase 1-3 use DIAGNOSTIC mode. See section 8.2. Size setting mode is
required for Phase 1 spare (426518 Motor Controller and 426433 Display). For IW see service manual
Appendix E..
It is important to set the size switch setting into the Motor Controller’s memory whenever a replacement
Motor Controller or Display Module is fitted to Smartdrive. Failure to do this will result in Smartdrive
faulting with fault code 9.
Accessing size setting mode is the best way to check the size for Phase 4 & 5 and Phase 1 spare. The size
setting of Smartdrive may be checked in Diagnostic mode for all phases.
To set the size switch turn the power on at the power point and off at the console. Press and hold the
TEMPERATURE UP button then press the POWER button. Smartdrive will give 4 short beeps and the
pattern of LEDs will change.
• Press TEMPERATURE UP button, the COLD LED is on for 5-5.5kg (560mm wide).
• Press WATER LEVEL UP button, the LOW WATER LED is on for 6-6.5kg (600mm wide).
• Press SPIN SPEED UP button, the SPIN HOLD LED is on for 7-7.5kg (650mm wide).
• Press POWER to exit this mode.
MACHINE SIZE SET UP
EACH KEY SELECTS A SIZE & THE LED
ABOVE THE KEY INDICATES THE SIZE SELECTED
WASH
TEMP
DELAY
START
START
PAUSE
WATER
LEVEL
SPIN
SPEED
O O O
O O O
O O O
O
FAST
MED
SLOW
HOLD
HIGH
MED
LOW
HOT
WARM
COLD
A
DVANCE
POWER
SPINRINSE
FINAL
RINSE
SIZE SWITCH SET UP
MODE
PRESS TEMP UP &
POWER TO ENTER
THIS MODE
5.kg
5.5kg
6.5kg 7.5kg
SIZE
SI
Z
E SIZE
5- 5.5kg
6.5kg 7.5kg
LED on
LED off
If the size is set incorrectly Smartdrive will have the following settings incorrect: -
• The Auto Water Levels chosen by Smartdrive may be wrong.
• The High Water Level may be wrong by as much as 40mm.
• The flow rate for inlet water, normally 3 litres per minute, may be set incorrectly.
• The wash profile controls the strength of the agitator. This could result in poor wash performance or
splashing.
• Water saver settings.