Filter
Top Products
- 71 -
3. Ease the shaft through the bearings from inside the outer bowl. Take care the shaft is fitted with
the threaded retaining nut section facing downwards in the direction of the base.
4. Fit the shaft retention nut. Use the spline tool and spanner to tighten the shaft retention nut.
5. Invert the outer bowl. Take care not to damage the shaft or flooring. Fit the assembly thimble
sleeve onto the shaft before fitting the seal. Lubricate the seal outside diameter with liquid
detergent and then slide into position by pressing down on both sides of the seal.
NB: The seal should be flush with the lip on the base of the outer bowl.
NB: The outer bearing will be proud of
the housing by approximately 3mm.