Filter
Top Products
- 1 -
1.0 INTRODUCTION
1.1 HOW TO SERVICE SMARTDRIVE
IF SMARTDRIVE HAS NO POWER - SEE SECTION 6.1
Power off at the mains socket. Wait 2 minutes. Power on.
IF SMARTDRIVE IS DISPLAYING A FAULT - SEE SECTION 11.0
This may be identifiable by an unusual combination of LEDs displayed on the
wash progress LEDs. Smartdrive will be making a continuous sound of
beeping repeating once every second and will be PAUSED. Phase 1-3 Only
press spin buttons until the SPIN HOLD and SPIN SLOW LEDs are on. The
wash progress LEDs correspond to the 8 bit binary fault code with the spin
LED representing the least significant bit. On LW or AW leftmost LED may
be obscured by the front panel overlay, this is the most significant bit. (NB.
The LEDs will not be flashing).
IF SMARTDRIVE IS DISPLAYING A USER WARNING
– SEE SECTION 10.0
This may be identifiable by an unusual combination of LEDs flashing and / or
Smartdrive may be making a rippling sound of 5 beeps repeating every 6 seconds.
IF SMARTDRIVE APPEARS TO HAVE NO FAULT
Find the last fault. It may be accessed from Diagnostic Mode.
Diagnostic mode is accessed by pressing ‘Wash Temp Down’
and ‘Power’ buttons together, Smartdrive will give 2 quick
beeps in acknowledgement. (Phase 1 & 2 Only press
ADVANCE key once). Go to level 3 by pressing the Spin
buttons until the SPIN HOLD and SPIN SLOW LEDs are on.
The wash progress LEDs correspond to the 8 bit binary fault
code with the spin LED representing the least significant bit.
This fault would have occurred within the last 8 cycles. If all the wash progress LEDs are off, there is no fault.
Do not change Motor Controller. If there is no fault, (above) and the product will not start check that the lid
switch is operating correctly. This may also be done from Diagnostic Mode, see SECTION 8.2.
Set Restart OFF, (activate the Low Water LED while in Diagnostic mode). This will allow Smartdrive to detect
faults quicker, it will not retry. Exit Diagnostic mode.
Test Smartdrive by filling (using both valves), draining and spinning to 1000RPM. Open lid when at
1000RPM. Check the size and the operation of the Out of Balance lever.
IF SMARTDRIVE WILL NOT START it could be that the lid
switch indicates that the lid is open.
IF SMARTDRIVE IS LEAKING – SEE SECTION 6.4
IF SMARTDRIVE IS NOISY – SEE SECTION 6.5
IF SMARTDRIVE HAS OTHER FAULTS
– SEE SECTION 6.0
If you have Smarttool, it will identify the last four faults and the last user
warning. It will provide appropriate servicing instructions.