Filter
Top Products
23
The dryer should be level with all four feet firmly on the
ground. The dryer must not wobble.
If the dryer is not level or if it does wobble, the legs must
be adjusted. Refer to Figure 22. Adjust the leveling legs
until the dryer does not rock and is level, both
front-to-back and side-to-side.
Figure 22.
Step 8
Connect Duct System to Dryer
(Model WTA 3510 only!)
Connect the exhaust ducting system to the dryer exhaust
outlet.
Step 9
Final Check List
1. Review the electrical requirements (and for
WTA model the exhaust requirements) and steps
1 through 8 to make sure they were performed
properly.
2. Make sure the electrical supply is on.
3. Read the Use and Care Manual to fully understand
how your dryer operates. Turn on the dryer. Select
the ‘‘Heated Dry’’ cycle and let the dryer run for
2–5 minutes.
4. After 2–5 minutes stop the dryer and open the door.
You should feel heat inside the dryer.
5. If the dryer does not operate, refer to the
SELF-HELP and the SERVICE and REPAIR sections
of the Use and Care Manual.
6. Upon completing check, turn dryer off.
7. LEAVE INSTALLATION INSTRUCTIONS AND USE
AND CARE MANUAL WITH OWNER.