Filter
Top Products
22
L Ground
Figure 20.
11. Check the nut on the U.L. strain relief clamp to make
sure that it is tight and the strain relief clamp cannot
turn.
12. Replace the cover on the junction/splitter box and
fasten in place.
The dryer is now ready to be plugged into the 3-wire
receptacle, of the proper rating.
Note: The receptacle should be located so that the plug
and receptacle will be accessible with the dryer in
its installed position.
Additional Grounding Procedure
Some local codes may require a separate ground. In
such cases, the required accessory ground wire, clamp
and screw must be purchased separately. Never
ground the dryer to plastic plumbing lines, gas lines
or hot water pipes.
Step 7
Position and Level the Dryer
Place the dryer in position on a clean, level, solidly
constructed floor. Installation on any type of carpeting is
not recommended.
With dryer in position, it must then be leveled. Check
dryer, using level as shown in Figure 21.
CAUTION
Do not slide dryer across the floor if leveling legs
have been extended. Legs and/or dryer base may be
damaged if dryer is slid across floor with leveling legs
extended.
Figure 21.