Filter
Top Products
10
7. Select ADDITIONAL FUNCTIONS, if desired
The additional functions available are accessible
by depressing the buttons:
‘‘Delicates’’
The ‘‘Delicates’’ button, see Figure 5, will reduce the
drying temperature and lengthen the drying time
when depressed. It is recommended that the
‘‘Delicates’’ button be depressed when drying heat
sensitive fabrics, such as, acrylics. Be sure to follow
the instructions listed on the care label instructions.
‘‘End of Cycle Signal’’
When the ‘‘End of Cycle Signal’’ button, see Figure 5,
is activated there will be a signal sounded at regular
intervals at completion of the selected program.
The volume level of the sound may be changed by
holding the button in until desired volume level is
reached. This volume level will be stored for future
use until altered.
The end of cycle signal can be switched off by
depressing the button again. The indicator light
above the button will turn off to indicate that the
signal is no longer selected.
8. Press the ‘Start’’ Button
Depress the ‘Start’’ button. The indicator light above
the ‘Start’’ button will become illuminated and the
machine will start. If one of the Auto Cycles has been
selected the Duotronic system will continuously
monitor the moisture level of the load and display the
progress in the ‘‘Moisture Level Indicator Lights.’’ If
a timed cycle has been selected, either Heated Dry
or Air Fluff, the minutes remaining in the program will
be shown in the ‘‘Cycle Countdown Display.’’
The program will continue to the end, when the
‘‘End’’ indicator lamp will become illuminated.
And if the ‘‘End of Cycle Signal’’ has been selected
a signal will sound.
Note: If using the Auto program at the beginning
of the cycle there will be numerous rotations
in each direction with complete stops in
between for approximately 90 seconds.
There is nothing wrong with the machine,
it is taking a reading on the moisture of the
load to determine how long to dry.
Note: If the load is not removed, the drum will,
for the following 35 minutes, rotate at brief
intervals to prevent wrinkling (Anti-Crease).
After 35 minutes this feature will cease its
function. It is recommended that the dryer
be unloaded no later than 35 minutes after
completion of program to avoid wrinkling.
Figure 5.
9. Depress the ‘‘Door’’ button
The door will open.
10. Remove the Laundry from the Dryer
11. Clean the Lint Filter
The lint filter, located in the door, should be cleaned
after each load. Cleaning the filter will shorten drying
times and save energy.
12. Turn Off the Dryer.
Depress the ‘‘On/Off’’ button.