Beko WMI 71641 Washer User Manual


  Open as PDF
of 48
 
EN
9
Removing packaging
reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Opening the transportation
locks
C
Transportation safety bolts must be
removed before operating the washing
machine!Otherwise,themachinewill
be damaged!
1. Loosen all the bolts with a spanner
untiltheyrotatefreely(“C”)
2. Remove transportation safety bolts by
turning them gently.
3. Fitthecovers(suppliedinthebagwith
theOperationManual)intotheholes
ontherearpanel.(“P”)
3
Installation
C
Keepthetransportationsafetybolts
in a safe place to reuse when the
washing machine needs to be moved
again in the future.
C
Never move the appliance without the
transportation safety bolts properly
fixed in place!
Appropriate installation location
Install the appliance in environments which
have no risk of freezing, in a stable and
level position.
C
The floor must be capable of carrying
the load on it!
C
If the washing machine and a drier
are placed on top of each other, their
approximate weight together may
reach 180 kg when they are full.
Important:
• Donotplacetheapplianceontopof
the power cable.
• Keepatleast1cmdistancefromthe
edges of other furniture.
• Placethemachineonafirmsurface;
do not position it on a long pile rug or
such like surfaces.
Raising the appliance
In order to raise the appliance to eliminate
the gap below the worktop, you will need
to order special optional kit.
PleasecallBekoSparePartDepartment.
(08456004911)andseebuilt-in
installation section.
Without optional
raising feet.
Gap
With optional raising
feet. Minimum
height=55 mm, max
height=65mm
Service Ref. No. 1493
 previous next