Beko WMI 71641 Washer User Manual


  Open as PDF
of 48
 
EN
28
• Pulloutthepumpoutlethosefromits
housing.
• Placealargecontainerattheendof
the hose. Drain the water off into the
container by pulling out the plug at
the end of the hose. If the amount of
water to be drained off is greater than
the volume of the container, replace
the plug, pour the water out and then
resume the draining process.
• Afterdrainingprocessiscompleted,
replace the plug into the end of the
hose and fit the hose back into its
place.
If your product is not supplied with an
emergency drain hose, do the following as
showninthefigurebelow:
• Placealargecontainerinfrontofthe
filter to receive water flowing from the
filter.
• Loosenpumpfilter(anticlockwise)until
water starts to flow out of it. Direct the
flowing water into the container you
haveplacedinfrontofthefilter.You
can use a piece of cloth to absorb any
spilled water.
• Whenthereisnowaterleft,turnthe
pump filter until it is completely loose
and remove it.
• Cleananyresiduesinsidethefilter
as well as fibers, if any, around the
propeller region.
• Ifyourproducthasawaterjetfeature,
be sure to fit the filter into its housing
in the pump. Never force the filter
while replacing it into its housing.
Fitthefilterfullyintoitshousing;
otherwise, water may leak from the
filter cap.
4- Close the filter cap.
Close the two-piece filter cap of your
product by pushing the tab on it.
Close the one-piece filter cap of your
product by fitting the tabs on the bottom
into their positions and pushing the upper
part of it.
 previous next