EN
27
• Closethetaps.
• Removethenutsofthewaterintake
hoses to clean the surfaces of the
filters on the water intake valves with
an appropriate brush.
• Ifthefiltersareverydirty,youcanpull
them out by means of pliers and clean
them.
• Takeoutthefiltersontheflatendsof
the water intake hoses together with
the gaskets and clean thoroughly
under streaming water.
• Replacethegasketsandfilters
carefully to their places and tighten the
hose nuts by hand.
Draining any remaining water
and cleaning the pump filter
Filter system in your machine prevents
solid items such as buttons, coins and
fabric fibers clogging the pump propeller
during discharging of the washing water.
Thus, a good water discharge is achieved
and the pump life is extended.
• Ifyourmachinefailstodrainthewater,
thepumpfiltermaybeclogged.You
may have to clean it every 2 years or
whenever it is plugged. Water must be
drained off to clean the pump filter.
In addition, water may have to be drained
offcompletelyinthefollowingcases:
• beforetransportingthemachine(e.g.
whenmovinghouse)
• whenthereisthedangeroffrost
In order to clean the dirty filter and
dischargethewater;
1- Unplug the machine to cut off the
supply power.
A
There may be water at 90°C in the
machine. the filter must be cleaned
only after the inside water is cooled
down to avoid hazard of scalding.
2-Openthefiltercap.Thefiltercap
may be composed of one or two pieces
according to the model of your machine.
If it is composed of two pieces, press the
tab on the filter cap downwards and pull
the piece out towards yourself.
C
If your machine is built-in, then it does
not contain a filter cover.
If it is composed of one piece, hold it from
both sides and open it by pulling out.
C
Youcanremovethefiltercover
by slightly pushing the kick plate
downwards with a screwdriver,
through the gap above the filter cover.
3- An emergency drain hose is supplied
withsomeofourmodels.Othersarenot
supplied with this item.
If your product is supplied with an
emergency drain hose, do the following as
showninthefigurebelow: